/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131"; Home>Bearing knowledge>Analysis: device method and precautions for bearing housing Analysis: device method and precautions for bearing housing
Bearing box device method and precautions: /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
First, the bearing box device:
1. Standard type: Several methods of using the snap ring and the fixed plate device bearing box. The bearing with the set screw device will cause the bearing shell to be deformed; it should be prevented as much as possible.
2. Flange type: When installing flange type linear bearing; the precision of the inner hole of the bearing box cooperated with it must be accurate.
3, adjustable type (small opening type): the opening on the bearing and the bearing box is straight; you can get a uniform preload in the circumferential direction.
4, large opening type: if used in cooperation with the appropriate bearing housing; large opening bearings can also be used for gap adjustment; even able to add light preload.
Second, the device should pay attention to:
1. When the linear bearing is installed in the bearing seat; auxiliary work should be used; prevent the end face or seal ring from being directly tapped; the bearing should be evenly introduced; use the buffer plate; by gently tapping and loading.
2. Pass the optical axis into the linear bearing; the center line of the shaft and the bearing must be in a straight line. If the shaft is twisted, the ball may fall; or the cage may be deformed; and the linear bearing may be damaged.
3. The applied load should be evenly distributed over the entire bearing; especially when receiving the load when 霎; two or more bearings should be used. The linear bearing does not accept the rotating load; otherwise it can cause accidents.
Recommend to friends comments close window Bearing related knowledge Application of rolling mill bearings
Three kinds of determination specifications for SKF angular touch ball bearing failures
SKF imported bearing operation in the inspection and fault handling of rolling bearings production - ferrule forming processing analysis
This article links to http://
Please indicate China Bearing Network http://
Previous:Analysis of the heat problem of IKO thrust ball bearing after the operation of the next section: The oscillating analysis method for the diagnosis of rolling bearing problems
Analysis: device method and precautions for bearing housing
Source: Bearing network time: 2013-07-01